Heating & Furnace Repair in Gilbert, AZ

No heat on a cold Gilbert morning

Gilbert heaters sit idle most of the year, so the first cold night in December is usually when a problem shows up. A furnace or heat pump that ran fine last winter can come back with a dirty flame sensor, a failed igniter or a stuck reversing valve. Call (480) 808-9990 or book online, and a licensed technician will find the cause.

Furnace or heat pump, we fix both

Gilbert homes mostly heat one of two ways. A gas furnace burns fuel and vents the exhaust outside. A heat pump uses the same outdoor unit that cools the house in summer, running in reverse. What breaks depends on which one you have.

• Gas furnace: a dirty flame sensor that lets the burner light and then shuts it off, a failed igniter, a limit switch tripped by a clogged filter, or a bang at startup from delayed ignition.
• Heat pump: a frozen outdoor coil, low refrigerant, a defrost problem or a failed reversing valve, so the unit runs but the air comes out cool.

The technician checks the thermostat's call for heat, power and gas supply, the ignition sequence and the safety switches. That way the repair goes after the real fault instead of a guess.

Upfront pricing

Repair visits have a $120 diagnostic, waived when you go ahead with the repair, and you get a written price before any work starts. If the system is old enough that replacing it makes more sense, the estimate is free.

Check these first, and know when to stop

Make sure the thermostat is set to heat and has fresh batteries, the breaker hasn't tripped and the filter isn't clogged. Don't open the furnace cabinet or touch the gas valve. If a breaker trips again after you reset it, leave it off and call us. If you smell gas, leave the house right away and call your gas company or 911 from outside.